Screw conveyor can not work properly powder reason and solution

The screw conveyor is a common conveying device suitable for conveying powder, granules and small pieces of material, but it is not suitable for conveying viscous materials. The structure of such a device is simple, but improper use can also cause serious accidents. Some spiral machines are not working, so let me talk about these reasons and help everyone.

There are three reasons for the screw shaft of the screw conveyor to stop running. There are both equipment and man-made reasons: the sealing of the equipment is not good enough. When conveying the powdery material, the material enters the bearing through the gap, causing the bearing. The card is dead or even damaged; the other is that the feed size is too large, the material can not enter the middle of the hanging bearing normally, causing the resistance in the middle of the device to increase, the motor load is large, and the machine is directly stopped. At the same time, the reducer is an important reason. The use of a gearbox of poor quality or inconsistent specifications may cause the bearing to burn out.

When the equipment is turned on, abnormal noise is emitted, the motor and the reducer vibrate, and the temperature of the bearing area increases sharply. We should stop the operation of the equipment in time. Check the installation of the screw shaft center money, motor fixing components, and reducer fixing bolts at all points, and check whether the decelerating bearing is burnt. Find problems, solve them in time, recalibrate the installations where problems exist, and ensure the safe operation of the equipment.

Some reasons for the screw conveyor to stop running are, in general, two problems, the problem of the equipment itself and the problem of personnel feeding. As long as you purchase reliable equipment and good maintenance of the staff, the operation of the screw conveyor must be smooth and smooth.